CncARtMetal

The rudder for SP600 mounted on the speedboat

New project : desk furniture alu 6082 legs with oak

Wired up the chip auger electronica today

When the program is running with doors closed and command with code M59 P114 the chip auger starts spinning every 15 minutes for 4 munutes long.

Testpart Xometry Germany

Improvement of my aircompressor

Replaced my SS flex to a copper tube

The rudder just out of the machine ‘guillotine’

Een van onze grote projecten in progress .

Hardjaws XL (350mm) machined

The rudder part 2

Replaced the SS flex to a copper tube

Project Chip auger finushed with succes

OP1 Honeycomb leg for desk furniture

OP1 first operation finished the honeycomb leg for desk

OP2 Second operation honey leg lay down on to the negative softjaws

L

Softjaws ready for OP2

Second operation finished with 7 toolchanges and again stepped up my RAPID no engagement feedrate in only one operation , rewritten the gcode 98000 lines of code . Hacked the cam software with succes. Very happy !